1,Components are allowed to work under the following conditions:
A. The relative humidity of the air is not greater than 95%, no explosive and corrosive gases.
B. The working voltage should not be greater than 1.1 times the rated value, the shell should be effectively grounded.
C. insulation resistance ≥ 1MΩ dielectric strength: 2KV / 1min.
2, the electric heating tube should be well positioned fixed, effective heating zone must be immersed in liquid or metal solid, forbidden to burn empty. When the surface of the tube body is found to have scale or carbonization, it should be cleared and reused in time to avoid affecting the heat dissipation and shorten the service life.
3, heating fusible metal or solid nitrate, alkali, leachate, paraffin, etc., should first reduce the use of voltage, to be melted medium, before rising to the rated voltage.
4, when heating air components should be crossed evenly arranged, so that components have good heat dissipation conditions, so that the flow of air can be fully heated.
5, when heating nitrate salt should consider safety measures to prevent explosive accidents.
6, the wiring part should be placed outside the insulation layer, avoid contact with corrosive, explosive media, water; lead wire should be able to withstand the temperature of the wiring part and heating load for a long time, wiring screws tightening should be avoided when the force is too hard.
7, the components should be stored in a dry place, if the insulation resistance is lower than 1MΩ due to long-term placement, can be dried in an oven at about 200 ℃, or reduce the voltage energized heating, until the recovery of insulation resistance.
8, electric heaters out of the end of the magnesium oxide powder, in the use of places to avoid contaminants and moisture infiltration, to prevent leakage accidents.
if you want to customize heater elements for your application,pls feel free to contact us:sales@heatersmfg.com
