Teflon fiberglass fabric sticking on roller that can replaces the traditional Teflon spraying. It has the characteristics of convenience, low technical requirements and durability. how to use teflon fiberglass fabric on roller? In order to make the Teflon fiberglass fabric to be longer service life on roller, there are 5 technical tips as following to be known:
1. Clean the surface of the drying cylinder that needs to be taped, and pay attention to the surface without iron filings and the surface is smooth.
2. Cut the teflon fiberglass fabric longer than the required length (about 5CM longer than the required length) for use.
3. Tear off the release paper. Pay attention to the side of the tape. Don't tear it all at once. You can use a piece of cloth (or newspaper) to rub the tape at the place where the tape is applied. Coincide.
4. Use a utility knife to cut a straight line (in the direction of the length of the drying cylinder) in the middle of the overlap of the teflon fiberglass fabric, tear off the tape at A (as shown in the picture) and open it
5. After pasting, carefully check whether there are small bubbles between the teflong fiberglass fabric and the drying cylinder. If so, you can use a pin or other sharp object to remove the small bubbles one by one and flatten them. Tear off the tape at B, stick the tape at B, and flatten the tape at B and D.
The size of high temperature teflon fiberglass fabric suitable for sticking rollers mainly uses two thicknesses of 0.13MM and 0.18MM. If you want to know about information of teflon fiberglass fabric, pls feel free to contact us:sales@heatersmfg.com.
